新闻中心
NEWS
客户服务热线
Customer Senvice Hotline
Common Methods for Weighbridge Calibration
Common Methods for Weighbridge Calibration
Calibration methods for commonly used models HT9800-A7/A7P, D7/D7P, A9/A9P, D6/D6P:
Press "Calibrate" in the weighing state, input the original password "888888", press "Enter" to display "CAL 1", press "2" to display "CAL 2", press "Enter", "Enter" to display "0", press the standard weight value to display this value, return to the weighing state, and the calibration is completed.
XK3190-A9, calibration method:
Turn on the calibration setting and turn the calibration switch to the allowable calibration position, Press "Function" to display "E * *" (graduation value), press "Enter" to display "dc *", press "Enter" to display "Pn 00124", press "Enter" to display "F ********", press "Enter" to display "noload", and the zero position is determined. At this time, there is nothing on the scale. After the stability marker is lit, press "Enter" to display "AloAd1" to load the standard weight, press "Enter" according to the standard weight, (if non-linear correction is required, press "Print" to display "AloAd2", and continue to add weights (greater than the last weight), press this weight, press "Enter", and then press "Enter" until the weighing status is returned.
DS-788 calibration method:
1. Short circuit the key, press the zero setting key to input 8715, and then press zero setting. After CRL59 appears, release the weight, and then press zero setting.
2. Start up the machine, the top and bottom holes will display "ds788 followed by STEt", press zero setting, press 8715 to display CAL00, press zero setting to display "---- CAL SP", fill the weighing weight, and press zero setting.
Calibration method of DS822-X6/X6p:
Enter the calibration state, press calibration 1 to display "sel1" (calibration zero position), press input to display "nolord", press input again after the scale is stable, display "------", wait for about 5-10 seconds, press input, display "0.00" to return.
In calibration status, press calibration 2 to display "sel2" (calibration loading point), press input to display "rdlord", load weights, wait until the scale is stable and then input the weight value, display "weight value", press input to display "weight value" and return
相关新闻
2022-04-28
2022-04-21